Specifications

CHAPTER 5 ERROR CODE
5-8
COPYRIGHT
©
1999 CANON INC. CANON SUPER G3 FAX BOARD-F1 REV.0 MAY 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
##106 (reception) procedure signal not received for 6 sec during reception
Cause Remedy
• The condition of the line is poor, and the pro-
cedure signal from the other party cannot be
received properly.
• The condition of the line is poor, and the other
device cannot receive image signals properly.
• An echo caused malfunction.
• Request the other party to raise the transmis-
sion level of the other device to ensure correct
reception of the procedure signal.
• Raise the transmission level of the modem
using parameter 07 of #2 MENU so that the
other device may receive signals properly.
1. Provide measures against echoes by referring
to the descriptions under #1 SSSW SW03.
2. Lower the transmission level of the modem
using parameter 07 of #2 MENU so as to pre-
vent reception of echoes of transmitted CFR.
##107 (reception) fall-back not possible on transmitting device during reception
Cause Remedy
• The condition of the line is poor, and the sig-
nals from the other device cannot be received
properly after starting 2400 bit/sec reception
mode.
• An echo caused malfunction.
1. Request the other party to raise the transmis-
sion level of the other device so as to ensure
correct reception of signals from the other
device.
2. Adjust the NL equalizer using parameter 05 of
#2 MENU so that the other device may receive
TCF properly.
3. Relax the RTN transmission conditions using
02 through 04 of #3 NUMERIC Pram. so as to
prevent transmission of RTN.
1. Provide measures against echoes by referring
to the descriptions under #1 SSSW SW03.
2. Lower the transmission level of the modem
using parameter 07 of #2 MENU.
##109 (transmission) non-DIS, -DTC, -FIT, -CFR, -CRP received after transmission of DCS
during transmission, causing excess procedure signal re-transmission
Cause Remedy
• An error occurred in the procedure signal. • Make a recording of the exchange procedure
sound on DAT and request the technology
center for analysis.