Specifications

COPYRIGHT
©
1999 CANON INC. CANON SUPER G3 FAX BOARD-F1 REV.0 MAY 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
5-5
CHAPTER 5 ERROR CODE
II. SERVICE ERROR CODES
G3 Mode Error code
##100 (transmission) excess re-transmissions of procedure signal during transmission
Cause Remedy
• If after transmission of Q following image data,
The line condition is poor, and the other device
cannot receive image data or the Q signal
properly.
• If after transmission of TCF preceding image
data,
The level of transmission is low, and the other
device cannot receive the signals properly.
• If after transmission of TCF preceding image
data,
The other device malfunctioned because of an
echo.
• Increase the transmission level of the modem
using parameter 07 of #MENU so that the
other device may receive image data or Q
properly.
2. Lower "transmission speed" under "system
control" in user mode.
3. Adjust the NL equalizer using parameter 05 of
#2 MENU so that the other device may receive
image data or Q properly.
4. Add an echo protect tone to the V.29 modem
signal using bit 1 of SW03 in #1 SSSW.
• If after transmission of TCF preceding image
data,
Raise the transmission level of the modem
using parameter 07 of #2 MENU so that the
other device may receive the signals properly.
• If after transmission of TCF preceding image
data,
1. Provide measures by referring to the descrip-
tions for S#1 SSSW SW03.
2. Put a longer pause to the telephone number
when registering for auto dial so as to avoid
response to the first DIS from the other device.
3. Press the Start key only after hearing the first
DIS from the other device in manual ringing.