Specifications

CHAPTER 4 SERVICE MODE
4-32
COPYRIGHT
©
1999 CANON INC. CANON SUPER G3 FAX BOARD-F1 REV.0 MAY 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
10. Printer Parameter Settings (#7 PRINTER)
a. Service Soft Switch Settings
#7 PRINTER-SW05 (reduction, cassette selection)
Bit 0
Use it to specify whether to give priority to LTR over LTR or LGL when data which may be printed
on either by division is received.
Bit 1
Use it to specify whether to give priority to LGL over A4 or LTR when data which may be printed
on either by division is received.
The order of priority will be as follows according to the bit 0 and 1 settings:
If sub scanning is given priority, the order will be LTR A4 LGL even when bit 1 and 1 are set
to 0.
Bit 4
Use it to specify whether to reduce and print on A4 paper.
If printing on non-A4 paper without reduction is desired when a long-size page is received, be sure to
select 'No'.
Bit 5
Use it to specify whether to reduce and print on LTR paper.
If printing on non-LTR paper without reduction is desired for a long-size page, be sure to select 'No'.
Bit 7
Use it to specify whether to place priority on sub scanning direction.
Yes:If B4 and A4 are set and an A4 long-size page* is received, prints on B4.
No: If B5R and A4 are set and an B4 page is received, divides and prints on B5R.
*Page B4 or less in length and which cannot be reduced for printing on A4.
05
0
1
3
4
1
1
0
0
Priority on LTR
Priority on LGL
Do not change
Reduction and printing on A
1
Yes
0
No
Yes No
No Yes
Yes No
No Yes
2 0Do not change
5 0Reduction and printing on LTR
6 0Do not change
7 0Priority to sub scanning
SW
No.
Bit
No.
Description
Bit setting
Default
Bit 0
0
1
1
0
Bit 1
0
0
1
1
Order of priority
A4 LTR LGL
LGL LTR A4
LTR LGL A4
LTR A4 LGL