Specifications

CHAPTER 4 SERVICE MODE
4-24
COPYRIGHT
©
1999 CANON INC. CANON SUPER G3 FAX BOARD-F1 REV.0 MAY 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
#1 SSSW-SW28: V.8/V.34 procedure settings
Bit 0
Use it to specify whether to execute the V.8 procedure when making a ring.
No: Starts with the V.21 procedure without the V.8 procedure even if a V.8 procedure is received
from the callee.
Bit 1
Use it to specify whether to execute the V.8 procedure at time of a ring.
Yes: Starts with the V.21 procedure without the V.8 procedure.
Bit 2
Use it to specify whether to execute V.8 procedure if the ANSam signal from the callee cannot be
recognized but the callee declares the presence of the V.8 procedure in the DIS signal.
Yes: Sends a CI signal in response to the DIS signal from the callee, and executes the V.8
procedure.
No: Does not send a CI signal in response to the DIS signal from the callee, and executes the V.21
procedures.
In the case of manual transmission, V.8 late start will not be executed regardless of how the bit is set.
Bit 3
Use it to specify whether to declare the presence of the V.8 procedure for the DIS signal to be sent
when the caller cannot recognize the ANSam.
Yes: Declares the presence of the V.8 procedure in the DIS signal and executes the V.8 procedure
after the caller transmits a CI signal.
No: Does not declare the presence of the V.8 procedure for the CI signal and executes the V.21
procedure.
In the case of manual transmission, V.8 late start will not be executed regardless of how the bit is set.
Bit 4
Use it to specify whether to prohibit fall back initiated by the V.34 receiving device.
Yes: Prohibits fall back initiated by the receiving device.
28
0
1
3
4
0
0
0
0
V.8 procedure for caller
V.8 procedure for callee
V.8 procedure for caller
Fall back from V.34 receiving device
1
No
0
Yes
No Yes
No Yes
No Yes
No Yes
2 0V.8 late start for caller
5 0Reserved
6 0Reserved
7 0Reserved
SW
No.
Bit
No.
Description
Bit setting
Default