Specifications
CHAPTER 4 SERVICE MODE
4-12
COPYRIGHT
©
1999 CANON INC. CANON SUPER G3 FAX BOARD-F1 REV.0 MAY 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
Bit 3
Use it to select an appropriate reception mode after transmission of the CFR signal.
If an error tends to occur often because of line condition during reception, select "high-speed" and, at
the same time, select "No" to "ECM reception."
Memo
The following is a list of error codes that may occur because of line condition during reception:
##107, ##114, ##201
Before changing this bit, be sure to change bit 4; if an error still occurs after changing bit 4,
change this bit.
If "high-speed" is selected, only high-speed (image) signals will be received after transmission
of a CFR signal.
Bit 4
Use it to set a time length during which low-speed signals are ignored after transmission of the CFR
signal.
If the line condition is poor and reception of image signals is difficult, select "1500 ms."
Bit 6
Use it to specify whether to transmit a CNG signal at time of manual transmission.
Bit 7
Use it to specify whether to transmit a CED signal at time of manual transmission.
If the other device does not start transmission in response to manual reception mode, select "Yes."