Specifications

COPYRIGHT
©
1999 CANON INC. CANON SUPER G3 FAX BOARD-F1 REV.0 MAY 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
4-11
CHAPTER 4 SERVICE MODE
#1 SSSW-SW04 communication problem prevention settings
Bit 2
Use it to select the appropriate number of last flag sequences for the procedure signal (300 bps). If the
procedure signal sent by the device is not received normally by the other device, set it to "2."
Memo
The following is a list of error codes that may occur at time of transmission:
##100, ##280, ##281, ##750, ##753, ##754, ##755, ##758, ##759, ##760, ##763, ##764,
##765, ##768, ##769, ##770, ##773, ##775, ##778, ##780, ##783, ##785, ##788,
04
0
1
3
4
5
6
7
0
0
0
0
0
0
1
Do not change
Do not change
Reception mode after transmission of
CFR signal
Time length in which low-speed signal is
ignored after transmission of CFR signal
Check on frequency of CI signal at time of
setting PBX
CNG signal for manual transmission
CED signal at time of manual reception
1
High speed
0
21
High speed/
Low Speed
2 0Number of last flag sequences (procedure
signal)
1500ms 700ms
Yes No
No Yes
No No
SW
No.
Bit
No.
Description
Bit setting
Default