Specifications
COPYRIGHT
©
1999 CANON INC. CANON SUPER G3 FAX BOARD-F1 REV.0 MAY 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
3-11
CHAPTER 3 MECHANICAL SYSTEM
D. Installing the Expansion
Board Base Unit
1) Remove the four screws, and detach the
rear cover.
2) As shown in the Installation Procedure for
the expansion board base unit, install the
expansion board unit to the copier.
(However, do not mount the expansion
case cover at this point.)
· Install the expansion base unit to the
copier with three screws.
· Connect the two connectors.
Figure 3-224
7-pin connector
2-pin connector
Screws
3) Put the two connected connectors through
the gap on the left of the expansion base
unit, and make sure that the connector
harnesses will not interfere with the
flywheel.
Figure 3-225
4) Mount the speaker, speaker holder, and
wire holder.
Push in.
Push in.
Connectors