Specifications

CHAPTER 3 MECHANICAL SYSTEM

3-4

1999 CANON INC. CANON SUPER G3 FAX BOARD-F1 REV.0 MAY 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)

8) Disconnect the speaker connector from the

fax PCB.

9) Check to make sure that no connector is

connected to the fax PCB or the NCU

PCB; then, pull out the fax PCB from the

extension kit with care.

Figure 3-207

FAX board

Speaker cable

2. Installing the Fax Board

Caution:

When fitting the modular harness or the

ARG cable to the fax board, be sure to

support the connector from below so as

not to deform the PCB.

1) Insert the fax board halfway into the

topmost slot of the expansion unit.

2) Mount the speaker cable to the fax PCB.

Figure 3-208

Speaker cable

FAX board

Push halfway in.