User`s guide

Before Scanning
21
1
2
3
4
5
FilmGet FS User’s Guide
Macintosh Setup
System Requirements
The computer you use to run FilmGet FS must meet the following minimum requirements. Check your
computer and install FilmGet FS onto the hard disk drive.
• Operation is not guaranteed on Macintosh-compatible computers.
• Only one CanoScan scanner may be connected to a computer at a time.
• Please note that the system may become unstable because the computer’s energy saving mode
(sleep mode) is not supported.
Installing FilmGet FS
Install FilmGet FS according to the instructions in “1. Installing the Software” of “Chapter 3
Using the Scanner with a Macintosh” in Getting Started supplied with the scanner.
Computer
USB connection: Macintosh with standard USB configuration
SCSI connection: Macintosh with standard SCSI configuration or
SCSI card installed
Operating System
Mac OS 8.6 - 9.1
CPU
Power PC G3 or greater
RAM
64 MB or more (128 MB or more recommended)
Display
32,000 colors or better, 800 x 600 pixels or better
Interface
USB 1.1/SCSI II
Hard Disk Capacity
500 MB or more (1 GB or more recommended) available after
installing the application program
CD-ROM Drive
Required
Required Application
Program
Photoshop LE or other plug-in compliant application program