Wired LAN Instruction Manual
Table Of Contents
- EOS-1D X Mark II
- Introduction
- Basic Network Settings
- Transferring Images to an FTP Server
- Operating Remotely Using EOS Utility
- Operating Remotely Using WFT Server
- Operating Remotely Using a Smartphone
- Synchronizing the Camera Time
- Terminating the Connection and Reconnecting
- Checking and Operating Connection Settings
- Troubleshooting Guide
- Reference
99
Responding to Error Messages
Are you following the correct procedure to establish a
connection between the master and slave cameras?
X Operate the master and slave cameras by following the correct
instructions (p.68-70).
Is the master camera too far from the slave cameras?
X Bring the master and slave cameras closer together.
Is the LAN cable securely connected?
X Reconnect the LAN cable between the camera and server.
Because the cable may be severed, try using another cable to
connect the devices.
Is the hub or router on?
X Turn on the hub or router.
Is the power of the FTP server on?
X Turn on the FTP server. The server may have been turned off
because of an energy-saving mode.
A problem other than error code number 11 to 81 occurred.
X Turn off and on the camera’s power switch.
73: Could not synchronize the time
81: Wired LAN connection lost
91: Other error