Wired LAN Instruction Manual
Table Of Contents
- EOS-1D X Mark II
- Introduction
- Basic Network Settings
- Transferring Images to an FTP Server
- Operating Remotely Using EOS Utility
- Operating Remotely Using WFT Server
- Operating Remotely Using a Smartphone
- Synchronizing the Camera Time
- Terminating the Connection and Reconnecting
- Checking and Operating Connection Settings
- Troubleshooting Guide
- Reference
89
Responding to Error Messages
In the case of [EOSUtility], is EOS Utility running?
X Start EOS Utility and re-establish the connection (p.40).
In the case of [Smartphone], is Camera Connect running?
X Establish a connection using Camera Connect (p.60).
Are the target device and access point turned on?
X Turn on the target device and access point, then wait a while. If a
connection still cannot be established, perform the procedures to
establish the connection again.
What to check on the camera
On the camera, IP address is set to [Auto setting]. Is this the
correct setting?
X If no DHCP server is used, configure settings after setting the IP
address to [Manual setting] on the camera (p.106).
11: Connection target not found
12: Connection target not found
21: No address assigned by DHCP server