Wired LAN Instruction Manual
Table Of Contents
- EOS-1D X Mark II
- Introduction
- Basic Network Settings
- Transferring Images to an FTP Server
- Operating Remotely Using EOS Utility
- Operating Remotely Using WFT Server
- Operating Remotely Using a Smartphone
- Synchronizing the Camera Time
- Terminating the Connection and Reconnecting
- Checking and Operating Connection Settings
- Troubleshooting Guide
- Reference
68
Connect the cameras to each other directly with a LAN cable. When
there are multiple slave cameras, connect them to a hub with LAN
cables, and connect the hub to the master camera with a LAN cable.
Steps 1 to 5 are the same on the master and slave cameras.
1
Select [Communication settings].
Under the [53] tab, select
[Communication settings], then
press <0>.
2
Select [Network settings].
Set [Communication func] to
[Enable], then select [Network
settings].
3
Select [Sync time between
cameras].
If connected to another device, [Set
[Connection settings] to
[Disconnect]] will appear. Select
[OK] to terminate the connection.
4
Select [OK].
Synchronizing the Time
Synchronize the camera time between the same camera
models.
If the camera models of the master camera and slave cameras are different,
synchronizing the time with slave cameras is not possible.