Service manual

2. LIST OF ERROR DISPLAY / INDICATIONS
Errors and warnings are displayed by the following ways:
1) Errors are indicated by the number of times the Power / Alarm LED lights / blinks.
2) Errors and warnings are displayed on the LCD monitor.
3) Errors and warnings are displayed on the printer driver's Status Monitor.
2-1. Operator Call Errors
(Alarm / Power LED lights)
2-2. Service Call Errors
(by cyclic blinking of Alarm / Power LED, or the condition in which Alarm LED remains lit and Power
LED off)
LED
display
Error [Error code]
Solution Remarks
Alarm
LED lit
No paper. (ASF) [1000] Set the paper in the ASF, and press the
Reset button.
Alarm
LED lit
Paper jam. [1300] Remove the jammed paper, and press the
Reset button.
Alarm
LED lit
No ink tank. [1662]
Install an ink tank, and press the Reset
button.
Alarm
LED lit
- The print head is not
installed, or it is not
properly installed. [1401]
- EEPROM data of the print
head is faulty. [1403 /
1405].
- Install the print head properly, and close
the access cover, or, with the print head
installed, turn the printer off and on.
- If the error is still not resolved, the print
head may be defective. Replace the print
head.
Alarm
LED lit
Warning: The waste ink
absorber is almost full
(approx. 95% of the
maximum capacity). [1700]
Pressing the Reset button will exit the
error, and enable printing.
In repair servicing, replace the ink
absorbers.
The service call error, indicating the
waste ink absorber is full, is likely to
occur soon.
Alarm
LED lit
The connected digital camera
or digital video camera does
not support Camera Direct
Printing. [2001]
After removing the cable between the
camera and the printer, press the Reset
button, and re-connect the cable. If the
error is still not resolved, a non-supported
camera may be connected. Connect a
supported camera.
Access cover open. [1200] Close the access cover.
Cyclic
blinking :
Alarm / Power LED
Error [Error code]
Solution
(Replacement of listed parts, which are likely to be faulty)
2 times Carriage error [5100] - Carriage unit (QM2-3257)
- Timing slit strip film (QC1-5153)
- Logic board ass'y (QM2-2880)
*1
- Carriage motor ass'y (QM2-1744)
3 times Paper feed error [6000] - Timing sensor unit (QM2-2894)