ImageBrowser_v3_guide

7 ImageBrowser Software User Guide
Chapter 1
Try It! ImageBrowser
Starting ImageBrowser (4/4)
Starting ImageBrowser with Mac OS X
With Mac OS X, you can start ImageBrowser using the
following procedure.
IMPORTANT
•You can also use this procedure to start ImageBrowser in Mac
OS X when using a memory card reader.
1.
Connect the camera to the computer using a USB
cable.
Read the guides that accompanied your camera for instructions
to connect the camera to the computer. Some models cannot
connect with the computer unless you set it to a particular
mode, such as the Replay mode. As described in the guides for
these models, set the camera to the correct mode to transfer
data.
2.
Close iPhoto or Image Capture if either program starts up.
3.
Double-click the [Canon ImageBrowser] icon on the
desktop.
ImageBrowser starts.
REFERENCE
• Depending on the selections you make during installation, the
Canon ImageBrowser icon may not appear on the desktop. In
this case, start ImageBrowser by double-clicking on the
application using the following sequence.
Locate and open the [Canon Utilities] folder, then open the
[ImageBrowser] folder and double-click on the [ImageBrowser]
icon.