Technical data

2-6 Using the FieryBar

Restarting the ColorPASS

You should use the procedure described below to restart the ColorPASS rather than

using the power switch on the back of the ColorPASS.

TO RESTART THE COLORPASS:

1. Make sure that the ColorPASS is not receiving, processing, or printing a job.

Make sure that the RIPping and Printing areas on the FieryBar both read Idle.

NOTE: If a job from the Print queue is processing, it will continue processing and print

after the ColorPASS is restarted; if a job sent to the Direct connection is processing, it

will not ﬁnish processing or printing.

2. Right-click the FieryBar, and choose Restart Fiery from the menu that appears.

A Warning dialog box appears.

3. Click OK to restart the ColorPASS.