Technical data

1-7 Starting and shutting down the ColorPASS

Starting and shutting down the ColorPASS

Generally, you can leave the ColorPASS running all the time. This section describes

how to shut down and restart the ColorPASS when necessary.

Starting the ColorPASS

To start the ColorPASS, move the power switch on the back of the ColorPASS to the

On position. If the copier is also powered off, power it on before powering on the

ColorPASS.

Diagnostic messages appear on the ColorPASS Control Panel. If any diagnostics fail,

more information and instructions appear. Contact your service representative if the

ColorPASS encounters problems while running the diagnostics. The ColorPASS

continues starting up and displays the message

Idle when it is ready to receive data.

NOTE: If an Administrator password has been set, you are required to enter it to access

Setup.

Power switch