Technical data

C
C-4 Troubleshooting
Disk full
The ColorPASS disk is almost full. In this state, a new job can only
be printed when the oldest printed job is deleted. This is not an
efficient way to print, and may lead to delays and printing errors,
so you should delete unneeded jobs from the Hold areas in the
Queues window (yellow job rows) and held jobs in the Archive
window. Also delete unneeded fonts. If these do not work, you can
use the
Clear Server command.
Finisher Alarm
There is an alarm in the finisher unit.
Finisher Jam
There is a paper jam in the finisher or buffer pass unit.
Finisher Open
The finisher or buffer pass unit is disconnected from the copier, or
the cover of the finisher or buffer pass unit is open.
ID mode
This message is displayed if your model requires that you enter a
security code.
Idle
This is a normal status message (LCD is solid green). The
ColorPASS is idle, waiting for the next job.
Invalid print job
The job that you sent could not be printed. Check the print
option settings before sending the job again.
Load staples
The copier’s stapler is out of staples. The ColorPASS will resume
printing when staples have been added.
Load ___ extra heavy
in __
The copier is not loaded with the extra heavy paper size specified.
The ColorPASS will print when the copier is loaded with the
required paper in the specified drawer.
Load ___ heavy paper
in __
The copier is not loaded with the heavy paper size specified. The
ColorPASS will print when the copier is loaded with the required
paper in the specified drawer.
Load ___ in manual
feed
The copier’s Stack Bypass drawer is not loaded with the paper size
or type specified. The ColorPASS will print when the Stack Bypass
drawer is loaded with the required paper.
Load ___ paper in __
The copier is not loaded with the paper size specified. The
ColorPASS will print when the copier is loaded with the required
paper in the specified drawer.
ColorPASS message: Corrective action/additional information: