Technical data

C
C-2 Troubleshooting
Change heavy setting
on the copier panel
To print on heavy paper media with the copier, you must register
the drawer containing transparencies on the copier touch panel
display. To register, press the Additional Functions key on the
copier button panel, and then press <media> Feed Location on the
copier touch panel display, select the drawer, and press OK. If you
want to send plain paper jobs to that drawer later, you need to reset
the drawer on the copier. Press the Additional Functions key, press
<media> Feed Location, and then press Cancel Registration. If you
fail to do this, the next plain paper job sent to that drawer displays
the error message “Load __ in __” because the drawer is still
registered for the specific media. The message stays up until you
reset the drawer.
Change thin setting
on the copier
To print on thin paper media with the copier, you must register the
drawer containing thin paper on the copier touch panel display. To
register, press the Additional Functions key on the copier button
panel, and then press <media> Feed Location on the copier touch
panel display, select the drawer, and press OK. If you want to send
plain paper jobs to that drawer later, you need to reset the drawer
on the copier. Press the Additional Functions key, press <media>
Feed Location, and then press Cancel Registration. If you fail to do
this, the next plain paper job sent to that drawer displays the error
message “Load __ in __” because the drawer is still registered for
the specific media. The message stays up until you reset the drawer.
Change trans. Setting
on the copier
To print on transparency paper media with the copier, you must
register the drawer containing transparencies on the copier touch
panel display. To register, press the Additional Functions key on
the copier button panel, and then press <media> Feed Location on
the copier touch panel display, select the drawer, and press OK. If
you want to send plain paper jobs to that drawer later, you need to
reset the drawer on the copier. Press the Additional Functions key,
press <media> Feed Location, and then press Cancel Registration.
If you fail to do this, the next plain paper job sent to that drawer
displays the error message “Load __ in __” because the drawer is
still registered for the specific media. The message stays up until
you reset the drawer.
ColorPASS message: Corrective action/additional information: