Technical data

4
4-37 Tray Alignment
NOTE: The Tray Alignment is specific to the combination of tray and paper size
specified. If you align Tray 1 with Letter paper, then load Legal paper in Tray 1, the
alignment will be invalid. You must perform a new Paper Tray Alignment for each
combination of tray and paper size.
4. In the Print alignment page section, click in the Print Duplex checkbox to print a
duplex page or leave the checkbox blank to print a simplex page.
5. Click the Print button to print the alignment page.
N
OTE: Be sure to print the alignment page.
6. Once the page has printed, follow the directions on the alignment page.
7. Fold the page in half horizontally, unfold it, and fold it in half vertically. When you
unfold the sheet again, you will see that the fold lines cross three scales on three
sides of the page. Determine the number where the fold line crosses each scale.
8. In the Enter alignment values section, type in the value where the fold crosses each of
the three scales, marked A, B, and C, for Side 1. If you choose to align for duplex
printing, the values for the three scales on Side 2 of the page should be entered as
well.
N
OTE: If you enter different values in A and C, the image will rotate, leading to
obvious, jaggy (rough, uneven edges) areas on printed output. If this occurs, enter the
same value in A and C.
9. Once all of the alignment values have been entered, click Apply. Click the Check
Alignment button to print the new alignment page.
10. If you want to remove the alignments, select a tray and click Defaults in the Enter
alignment values section.
11. Click Done when you are finished.