Owner's Manual

Page 23

The Paper Source option speciﬁed in the printer driver may be displayed as “InputSlot” in

the Command WorkStation Properties window.

When you print, the Paper Size option may not be displayed correctly in the Command

WorkStation Properties window or in the Fiery WebSpooler/Fiery Spooler Override Print

Settings window. However, the job will print on the paper size speciﬁed.

In the Mac OS version, if you check Thumbnails in the Scale menu in the Paper dialog box,

printed output will have toner scattered around the outer page frame. To correct this

problem, hold down the Option key while the job prints. Printed output will have the

outer page frame in gray as a result.

Adobe Photoshop

In applications like Adobe Photoshop in which an image does not occupy the entire page,

the non-image area will be printed as a CMYK image even though the job itself is saved as

an RGB ﬁle.

When printing from Adobe Photoshop on Windows 95/98, do not select Paper options

such as Size or Source in the Print Paper dialog box. Specify those options in the Fiery

Printing tab of the ColorPASS printer driver.

QuarkXPress for Windows

When you print a duplex print job using the Paper Source Alignment feature, the

alignment values speciﬁed for Side 2 will be applied to both Side 1 and Side 2.

QuarkXPress 4.04 for Windows 98

When you reopen a job saved after it has been printed to the ColorPASS, the Installed

Options list displays the options last selected in the Available Options list of the

Conﬁguration tab before the job was saved. For example, if a job was saved after it was

printed and if the Sorter with Stapler option was not installed at that point, the job would

not print using the Sorter Mode setting after it was reopened, even though the Sorter with

Stapler option was installed afterwards. As a workaround, print the job to the Hold queue,

and from the Command WorkStation, override the job settings from the job Properties

window, or from Fiery WebSpooler/Fiery Spooler, override the settings from the Override

Print Setting window.

QuarkXPress for Mac OS

If you print a job from QuarkXPress 4.04 on a Mac OS computer, the Paper Size setting

speciﬁed may not be displayed correctly from the job’s Properties window. You can access

these properties from the Command WorkStation, Fiery Spooler, or Fiery WebTools.

QuarkXPress 3.32 for Mac OS

You cannot select the following print options for the Printer Speciﬁc Options settings.

• Create Master

• Use Master

• Media Type

• Transparency Interleaving

• Slip Sheet

• Paper Source Alignment