Owner's Guide

3
3-36 Color Calibration
7. When prompted, select Yes to print the measurement page.
This page is comprised of swatches of color that will be measured by the copier and
then compared to the target color values. After the page is printed, the Measure Page
screen is displayed.
8. Select Yes in the Measure Page screen.
9. When prompted on the Control Panel, place the Kodak Gray Scale strip face down along
the top of the copier glass.
Place the strip so that it will be centered along the top edge of the AutoCal page.
10. Place the color measurement page face-down over the grayscale strip.
Place the page at the upper left-hand corner of the copier glass. Slide the grayscale strip
to the top center of the color measurement page. Make sure the patches on the
grayscale strip do not overlap the color patches.
11. Close the platen glass cover, being careful not to move the grayscale strip and color
measurement page.
12. Click OK.
Status messages display the progress of scanning and calculating measurements.
13. When prompted to Print Comparison Page (Expert Mode only), select Yes to print a
preview of the selected calibration.
Select from a list of output profiles that use the same calibration set and press OK.This
option appears only in Expert Mode calibration.
14. When prompted to overwrite calibration, select Yes.
15. Select Yes to confirm.
Status messages display progress information. When calibration is complete, the LCD
screen returns to the Functions menu.
Place color measurement page
face down over grayscale strip
Place grayscale strip
face down