imageCLASS MF8180c Software Guide

Installing Software on Your Computer
1-12
Installation
1
To Use the Machine as a Network Printer (Network
Connection)
IMPORTANT
The machine needs to be restarted for the specified settings to become effective. To
restart the machine, disconnect the power cord, wait for at least 10 seconds, and connect
the power cord again.
NOTE
• For details on specifying network settings, refer to Chapter 2, “Specifying the Network
Settings,” in the Network Guide.
• For additional network protocol settings, refer to the Network Guide.
• For the values of the network settings, consult your network administrator or internet
service provider (ISP).
Step 1 Specifying Network Settings
NOTE
• The machine is set to IP ADDRESS AUTO by default. If you are using DHCP you do not
need to make any changes and can move to “Step 2 Connecting the Machine to a
Network,” on p. 1-15.
1 Press [Menu] ➞ or to select <6.NETWORK SETTINGS>
on the LCD ➞ press [Set].
2 Press or to select <1.LAN SETTINGS> ➞ press [Set].
3 Press or to select <1.IP ADDRESS AUTO.> ➞ press [Set].
MENU
6.NETWORK SETTINGS
NETWORK SETTINGS
1.LAN SETTINGS
LAN SETTINGS
1.IP ADDRESS AUTO.