imageCLASS MF8180c Software Guide

MF Toolbox Settings
3-12
Scanning
3
Save Scanned Image to
You can specify the file name, file format, and location to save the scanned image.
When you select [PDF] as file format, you can also perform detailed settings for the
PDF file.
■ [File Name]
Enter a file name for the scanned image.
If you try to save another file with the same name, four digits starting from 0001 will be
attached after the file name.
■ [Save as Type]
The type of file which can be saved with each button is shown below.
If you select [PDF] in [Save as Type], depending on the output settings in the Advanced
Mode, an error message may appear indicating that the image size is too large. In such
cases, reduce the [Output Size] and/or [Output Resolution] under [Output Settings] to
reduce the [Data Size] of the scanned file.
If you select [JPEG] in [Save as Type] and then select [Newspaper (B&W)] in ScanGear
MF Simple Mode or [Black and White] in ScanGear MF Advanced Mode, the document
will still be saved in grayscale.
[BMP] Bitmap format.
[JPEG/Exif] JPEG/Exif format. This operation is available when [Grayscale],
[Color] or [Color (Magazine)] is selected in [Scan Mode].
[TIFF] TIFF format.
[PDF] PDF format.
[PDF (Multiple
Pages)]
Creates one PDF file from two or more scanned pages, see "Creating
One PDF File from Two or more Pages," on p. 3-16.
[PDF (Add Page)] Adds the scanned image to the last page of an existing PDF file that
was created with the MF Toolbox.
BMP JPEG/Exif TIFF PDF
PDF
(Multiple
pages)
PDF
(Add page)
[Mail] – –
[OCR] – – –
[Save]
[PDF] –––
[Scan-1], [Scan-2] – – –