imageCLASS MF8180c Facsimile Guide

Sending the Same Document to Several Recipients (Sequential Broadcasting)
4-12
Sending Faxes
4
● To use directory dialing:
❑
Press [Directory].
❑ Press a numeric key which contains the first letter of the desired destination.
❑ Press [ (-)] or [ (+)] to scroll through the required names until you find the desired
destination ➞ press [Set].
NOTE
• After entering the first one-touch speed dialing key or coded speed dialing code, you
have 5 seconds to enter another speed dialing key or code before the machine begins
sending automatically. If you have entered more than one speed dialing key or code, the
machine waits for 10 seconds before it begins sending. If you do not want the machine to
send automatically, you need to change <TIME OUT> in <TX SETTINGS> in <FAX
SETTINGS> of the Menu. (See <4. TIME OUT> of "Menu Descriptions," on p. 8-5.)
• To review the numbers you have entered, press [ (-)] or [ (+)].
4 After you have specified all of the destinations, press [B&W Start].
If you are using the platen glass, you will be prompted when the page has been
scanned. Place the next page (for a multipage document) ➞ press [B&W Start]. To
start sending, press [Set].
NOTE
• Regardless of the order you used when dialing, the machine sends the document to the
destinations you specified in this order: regular dialing numbers, one-touch speed dialing
numbers, then coded speed dialing numbers.
• Only one broadcasting job will be active at any given time.
• To cancel sending, press [Stop/Reset] ➞ follow the instructions in the LCD. When you
press [Stop/Reset], sending to all recipients will be canceled. You cannot cancel sending
to only one recipient. (Refer to Chapter 7, "System Monitor," in the Basic Guide.)