Service manual

Chapter 3
3-120
3) While pushing the boss [1], release the rotary release lever (right) [2] in
upward direction.
F-3-779
4) While pushing the boss [1], release the rotary release lever (left) [2] in
upward direction.
F-3-780
5) While paying attention to the engagement of the rotary release lever (left/
right) [1], lift the developing rotary assembly [2] to detach.
F-3-781
When mounting the developing rotary assembly, be sure that the 2 tips of the
rotary holder are fully fitted to the frame of the machine.
3.5.11.16 Removing the Developing Rotary/Toner Level
Detection PCB
0007-8854
1) Remove the 3 claws [1], and detach the developing rotary/toner level
detection PCB [2] from the developing rotary assembly.
F-3-782
3.5.12 Toner Cartridge Motor
3.5.12.1 Removing the Rear Cover
0007-8556
1) Disconnect the cable [1] of the power supply assembly.
2) Open the face-up cover [2], and remove the 4 screws [3] of the rear cover.
F-3-783
3) Open the reader assembly [4], and lift to free the 2 claws [5].
F-3-784
4) Close the reader assembly; then, detach the rear cover[1].
F-3-785
[1][2]
[1] [2]
[1]
[1]
[2]
[1]
[2]
[2]
[3]
[1]
[3]
[4]
[5]
[2]
[3]
[1]
[3]