Technical information

COPYRIGHT © 2001 CANON INC. 2000 2000 2000 2000 CANON CLC5000 REV.0 JAN. 2001
ERROR CODE
E-3
E006
Cause • Fixing drawer connector (fault)
• Fixing lever switch (SW5; fault)
• DC controller PCB (fault)
Description
0001 The fixing drawer connector connection signal CONNECT goes
‘0’ when the front cover is closed (i.e., the cover connector is dis-
connected).
0002 The fixing lever switch signal F-KBLK goes ‘1’ when the front
cover is closed (i.e., the releasing lever is not set).
E012
Cause • Drum drive system (overload)
• Drum motor (M21; error)
• DC controller PCB (faulty)
Description
0001 The rotation speed of the motor has deviated from a specific value
for 0.1 sec or more.
E013
Cause • Waste toner feeding motor (faulty)
• Waste toner feeding screw (rotation fault)
• DC controller PCB (faulty)
Description
0001 The rotation speed of the waste toner feeding motor has deviated
from a specific value for 0.1 sec or more (PLL signal ‘0’).
0002 The waste toner lock detection switch (SW4) has been pressed for
0.1 sec or more.
E014
Cause • Fixing motor (M9; error)
• DC controller PCB (faulty)
Description
The rotation speed of the motor has deviated from a specific value for 0.1
sec or more.
E015
Cause • Multifeeder pickup motor (M10; faulty)
• DC controller PCB (faulty)
Description
• The clock pulses of the pick-up motor cannot be detected.
• The rotation speed of the motor has deviated from a specific speed for
0.1 sec or more.