Technical information

COPYRIGHT © 2001 CANON INC. 2000 2000 2000 2000 CANON CLC5000 REV.0 JAN. 2001
SERVICE MODE
S-126
<M> <S> <R> <P> <F>
DISP
ADJUST
FUNC
REMOTE
COUNTER
OPTION
0
TEST
REMOTE
READY READY
P-PRT-MF
0
<REMOTE (making settings for use of extemal controller)>
F00-500-04
REMOTE
Use it to set priorities on parameters selected by the controller.
Settings 0: Use only the settings made on the copier’s control panel. For the
items that can be selected only on the controller, the factory settings
will be used.
1:Use the settings of the items that can be selected on the controller; for
the rest of the items, use those selected on the copier.
2:Use the settings of the items that can be selected on the controller; for
the rest of the items, use the factory settings.
P-RPT-MF
*1
Use it to set priorities on multifeeder setting data in case the mult: feeding
is selected from the control panel.
Settings 0: Use only the settings made on the copier’s control panel. For the
items that can be selected only on the controller, the factory settings
will be used.
1:Use the settings of the items that can be selected on the controller; for
the rest of the items, use those selected on the copier.
2:Use the settings of the items that can be selected on the controller; for
the rest of the items, use the factory settings.
Note 1: You must enter the appropriate value whenever you have replaced the
reader controller PCB or initialized a RAM; record any new values on the
service label for this purpose.