Technical information

COPYRIGHT © 2001 CANON INC. 2000 2000 2000 2000 CANON CLC5000 REV.0 JAN. 2001
CHAPTER 5 TROUBLESHOOTING IMAGE FAULTS/MALFUNCTIONS
5-112
4.1.6 E013
• Check the detail code of ‘E013’ using ‘DISPLAY > JAM/ERR’ in service mode.
Waste toner feeding screw
1) Is ‘0002’ indicated?
YES: The waste toner case is full, imposing excess load on the waste
toner feeding screw. Remove the waste toner as shown under
“F013-0002.”
Waste toner feeding motor (M20)
DC controller PCB
2) Set the meter to the 12VDC range. Does the voltage between
J2226A-5 (+) and J2226A-6 (–) on the DC controller PCB change
from 5 to 0 V when the Start key is pressed after turning off and
then on the power?
YES: Check the wiring; if normal, replace the waste toner feeding motor.
NO: Replace the DC controller PCB.
Waste toner lock detecting switch (SW4)
DC controller PCB
3) Is the voltage between J2223B-4 (+) and J2223B-5 (–) on the DC
controller PCB 0 V when the waste toner lock detecting switch is
pressed and 5 V when released?
NO: Replace the waste toner lock detecting switch.
YES: Replace the DC controller PCB.
■ E013-0002
1) Turn off the power switch.
2) Apply vibration to area A of the waste toner box [1] so that the toner moves from the
rear to the front.
A
[1]
F05-401-01