Technical information

COPYRIGHT © 2001 CANON INC. 2000 2000 2000 2000 CANON CLC5000 REV.0 JAN. 2001
CHAPTER 5 TROUBLESHOOTING IMAGE FAULTS/MALFUNCTIONS
5-27
23) Pour developer into the developing as-
sembly.
• Tilt the container while turning it to
avoid spilling the developer.
F05-205-06
24) When done, press the Stop key to stop
the operation of the developing assem-
bly.
25) Install the hopper metal fixings (left,
right), and release the locking mecha-
nism of the hopper assembly; then,
lower the hopper as far as the metal fix-
ings.
26) Remove the laser shutter opening tool.
27) Lift the hopper assembly to the topmost
position.
(At this time, the locking mechanism
will not work; lock it by hand.)
28) Clean the SALT sensor of the color in
question.
29) Remove the hopper retaining fixing
(left, right).
30) Release the hopper assembly, and move
it down to its specific position.
31) Select the 1st screen of ‘FUNC IN >
STALL’ in service mode.
■ Replacement for All Colors
32) Execute ‘STIR-4’. (about 4 min)
33) Execute ‘INIT-7’. (about 2 min)
34) Execute ‘WINCLR4’.
35) Record the results on the service label.
36) Execute ‘ADJUST > PASCAL > PAS-
CAL’ to select ‘1’.
37) Turn off and on the power switch.
38) Execute ‘auto gradation correction’ in
user mode.
Starter