Technical information

2-65
CHAPTER 2 NEW FUNCTIONS
COPYRIGHT © 2001 CANON INC. 2000 2000 2000 2000 CANON CLC5000 REV.0 JAN. 2001
g.Removing the Cleaner Assembly Scoop-Up Sheet
1) Remove the process unit from the
copier. (See the instructions on how to
remove the process unit.)
2) Separate the developing assembly and
the drum cleaner unit.
3) Remove the three screws [1], and detach
the cleaner assembly scoop-up sheets
[2] together with its support plate.
[1]
[1]
[1]
[2]
F02-405-33
h.Cleaning the Developing Assembly Bottom Cover and the Bearing
If you replaced the photosensitive drum
or the cleaning blade, be sure to clean
the developing assembly bottom cover
and the bearing as follows:
1) Slide out the process unit from the
copier.
2) Remove the developing assembly.
3) Remove the toner found in the area of
the developing assembly bottom cover
[1] indicated in the figure using a
blower brush or lint-free paper.
4) If toner is found sticking to the develop-
ing assembly front side plate or the
bearing [2] of the rear side plate, dry
wipe it using lint-free paper.
F02-405-34
[1]
[2]
[2]