User`s guide

Protocol Settings

3-24

Using a TCP/IP Network

IMPORTANT

•

If you set the startup time of the network function of the machine by following the procedure in

"Startup Time Settings," on p. 3-30, execute the PING command only after the time you set as

the startup time passes (the default setting startup time is '60 seconds').

•

If you connect the machine to a switching hub, the machine may not be able to connect to a

network even though your network settings are appropriate. This problem may be resolved by

delaying the startup of network communications for the machine. See "Startup Time Settings,"

on p. 3-30 for how to set up the startup time.

❑ Press [Done] ➞ press [▼] or [▲] until [SNTP Settings] appears ➞ press [SNTP Settings].

❑ Press [NTP Server Check].

<OK> is displayed if time synchronization is working correctly via SNTP.

NOTE

•

If <Error> is displayed, check the settings for [NTP Server Address] set in step 15.

•

Even if you perform [NTP Server Check], time settings are not updated. Check that

communications are possible between the machine and the NTP server.

Press [Done] repeatedly until the Additional Functions screen closes.

The TCP/IP settings are complete.

E-Mail/I-Fax Settings

IMPORTANT

To use the e-mail/I-fax functions, the optional equipment must be installed. For the equipment needed,

see "Optional Equipment and System Environment Requirements," on p. 1-2.

Press .