User`s guide

Interface Settings
2-12
2
Settings Common to the Network Protocols
● If you want the machine to automatically determine the communication mode
(Half duplex/Full duplex) and Ethernet type (10Base-T/100Base-TX):
❑ Select [On].
❑ Skip to step 8.
● If you want to manually specify the communication mode (Half duplex/Full
duplex) and Ethernet type (10Base-T/100Base TX):
❑ Select [Off].
❑ Proceed to step 6.
IMPORTANT
If you reconnect the network cable (for example, reconnect the cable to a different Ethernet hub)
with the power ON, the Auto Detect function will not work even if you set <Auto Detect> to 'On'.
(Connect the cable with the power OFF.)
NOTE
The default setting is 'On'. Use the [Off] setting to specify a particular Ethernet setting.
6 Specify <Communication Mode> on the Ethernet Driver Settings
screen.
● If you want to alternately send and receive:
❑ Select [Half Duplex].
● If you want to simultaneously send and receive:
❑ Select [Full Duplex].
7 Specify <Ethernet Type> on the Ethernet Driver Settings screen.
● If you want to establish a 10Base-T network connection:
❑ Select [10 Base-T].
● If you want to establish a 100Base-TX network connection:
❑ Select [100 Base-TX].