User`s guide

Setting Up a Computer as a File Server

4-18

Using a NetWare Network (Windows)

Setting Up a Computer as a File Server

To send data from the machine to a computer on your network, you need to specify the settings

of the computer for receiving data.

This section describes how to set up a computer as a file server.

IMPORTANT

•

To send data from the machine, the optional equipment must be installed. For the equipment needed,

see "Optional Equipment and System Environment Requirements," on p. 1-2.

•

To send a file to the NetWare server, make the following NetWare settings of the machine. For

instructions on how to specify the protocol settings, see "Protocol Settings," on p. 4-9.

- <NetWare>: [On]

- The Frame Type drop-down list: Frame type suitable for your environment

•

This section describes only the procedures for setting up a computer receiving data sent from the

machine. To send data from the machine to a server on the network, you must enter an address setting

from the control panel. For instructions on how to specify recipient address settings, see Chapter 2,

"Basic Sending Methods," in the Sending Guide.

•

In some environments, additional detailed settings such as authority settings may be required. For

details, consult the network manager of the environment you are using.

authority).

Set up the users and passwords for sending data from the machine.

Enter a user name and a password not longer than 24 alphanumeric characters.

Create a directory to be used for recipient addresses, and then enable

read access and write access by the users who will be sending data.