User`s guide

Main Power and Control Panel Power
1-18
1
Before You Start Using This Machine
❑ The screen below is displayed when the machine is ready to scan.
The machine is ready to scan in approximately 45 seconds (at a room temperature of 20°C)
after the screen above appears.
NOTE
• Once the message <Reservation copies can be made.> appears on the touch panel display, you
can specify settings, and copying or printing begins automatically as soon as the machine
becomes available. (See Chapter 1, "Introduction to the Copying Functions," in the Copying and
Mail Box Guide.)
• In the case above, the standard settings are selected.
• The standard copy settings are:
- Copy Ratio: 1 : 1 (100%)
- Paper Selection: Auto Paper Selection
- Copy Exposure: Manual Exposure Control
- Copy Quantity: 1
- Copy Function: 1 1-sided copy
- Colour Mode: Auto-Color Selection
• The standard settings for each function of the machine (Copy, Mail Box, Send, and Fax) are
already set at the factory, but you can change them to suit your needs. (See Chapter 7,
"Customizing Settings," in the Copying and Mail Box Guide, and Chapter 9, "Customizing
Communications Settings," in the Sending and Facsimile Guide.)
• You can select which functions to display on the Basic Features screen when turning ON the
main power, according to the Additional Functions settings. (See "Additional Functions Settings
Table," on p. 4-5.)
• If you press [ ➞ ] on the Basic Features screen right after the machine is activated, the screen will
be blank. Wait for a moment, then press [
➞ ] again.