User`s guide

Routine Cleaning
7-42
7
Routine Maintenance
6 Close the right feeder cover.
CAUTION
When closing the feeder cover, be careful not to get your fingers caught, as this may
result in personal injury.
Cleaning the Inside of the Main Unit
If streaks appear on printed output or random parts of the printed image are missing, the inside
of the main unit may be dirty. If this happens, clean the inside of the main unit, as described
below.
Cleaning inside Main Unit is a mode in Additional Functions. For information on the flow of
Additional Functions operations, see "What Are Additional Functions?," on p. 4-2.
NOTE
It takes about 90 seconds to clean the inside of the main unit.
1 Press ➞ [Adjustment/Cleaning] ➞ [Cleaning inside Main Unit].
2 Press [Start].
To cancel cleaning, press [Cancel].
While the inside of the main unit is being cleaned, the screen below appears.
When cleaning is complete, the message <Cleaning inside the main unit is complete.> appears
for approximately two seconds on the touch panel display.
The display returns to the Adjustment/Cleaning screen.
The inside of the main unit is now clean. Try printing again.