User`s guide

MEAP Settings

6-36

System Manager Settings

MEAP Settings

You can print information about installed MEAP applications. You can also specify HTTP (Hyper

Text Transfer Protocol) settings for MEAP if required by the MEAP applications you are using.

MEAP Settings is a mode in Additional Functions. For information on the flow of Additional

Functions operations, see "What Are Additional Functions?," on p. 4-2.

Use HTTP Server

Set Use HTTP to 'On' to access this machine from a Web Browser and utilize the installed

MEAP applications.

IMPORTANT

Setting Use HTTP to 'On' enables you to register and edit SDL user information. It also enables you to

use the Remote UI.

NOTE

•

Set Use HTTP to 'On' if the HTTP server is required for MEAP functions and MEAP applications. To use

HTTP for functions other than MEAP functions, set Use HTTP in Network Settings to 'On'. (See Chapter

3, "Using a TCP/IP Network," in the Network Guide.)

•

If you set Use HTTP in System Settings from the Additional Functions screen to 'On', the port number

for the MEAP functions and MEAP applications is automatically set to '8000'.

•

The default setting is 'On'.

Press ➞ [System Settings] ➞ [MEAP Settings] ➞ [Use HTTP].

Select [On] or [Off], and press [OK].

If you do not want to use HTTP, press [Off].

The specified mode is set.

NOTE

This setting is enabled only after you restart the machine (the main power switch is turned OFF,

then back ON again).