User`s guide

Adjusting the Machine
4-62
4
Customizing Settings
2 Press [Start].
To cancel cleaning, press [Cancel].
While the inside of the main unit is being cleaned, the screen below appears.
When cleaning is complete, the message <Cleaning inside the main unit is complete.> appears
for approximately two seconds on the touch panel display.
The display returns to the Adjustment/Cleaning screen.
The inside of the main unit is clean. Try printing again.
Automatic Feeder Cleaning
If your originals have black streaks or appear dirty after scanning them through the optional
feeder, clean the rollers of the feeder by repeatedly feeding blank sheets of paper through it.
IMPORTANT
This procedure is necessary only if the optional Color Image Reader-C1 and Feeder (DADF-K1) are
attached.
NOTE
It takes about 20 seconds to clean the feeder.
1 Press ➞ [Adjustment/Cleaning] ➞ [Feeder Cleaning].
2 Place 10 sheets of blank paper into the feeder ➞ press [Start].
Make sure that you fan the sheets of paper well.
Use A4 paper (60 to 80 g/m
2
).
To cancel Feeder Cleaning, press [Cancel].
While the feeder is being cleaned, the screen below appears.
When cleaning is complete, the message <Finished cleaning the feeder.> appears for
approximately two seconds on the touch panel display.
The display returns to the Adjustment/Cleaning screen.
The feeder is clean. Try scanning again.
NOTE
To cancel Feeder Cleaning when it is in progress, press [Cancel].