User`s guide

Adjusting the Machine
4-56
4
Customizing Settings
1 Press ➞ [Adjustment/Cleaning] ➞ [Saddle Stitcher Staple
Repositioning].
2 Press [Start].
To cancel the saddle stitch staple repositioning procedure, press [Cancel].
A screen informing you that the staples are being repositioned appears.
When the machine is finished repositioning the staples, the message <Finished repositioning
staples.> appears for approximately two seconds on the touch panel display.
Saddle Stitch Position Adjustment
If you are using the Saddle Stitch mode of the optional Saddle Finisher-N2, and you notice that
the folds of the paper are not exactly in the middle of the booklet, you can make adjustments to
the saddle stitch position to compensate for this error.
IMPORTANT
The saddle stitch position can only be adjusted if the optional Saddle Finisher-N2 is attached.
1 Press ➞ [Adjustment/Cleaning] ➞ [Saddle Stitch Position
Adjustment].
2 Select the paper size for which you want to adjust the saddle stitch
position.
NOTE
Some of the paper sizes displayed may not be available in certain countries.
3 Press [ ] or [ ] to adjust the saddle stitch position ➞ press [OK].
The adjustment range is from -2.0 mm to +2.0 mm, in 0.25 mm increments.
The selected mode is set.