User`s guide

Specifying Common Settings
4-50
4
Customizing Settings
Setting the Gamma Value for Remote Scans
You can set the gamma value that is used for scanning colour documents into your computer
through the Network Scan function. Select a gamma value that is most suited to your computer
settings so that you can print the document from your computer with the most optimal density.
NOTE
• [Gamma Value for Remote Scans] appears only if the optional Color Image Reader-C1 and the optional
network scan function is installed.
• For more information on the Network Scan function, see the Color Network ScanGear User's Guide.
• The default setting is 'Gamma 1.8'.
1 Press ➞ [Common Settings] ➞ [Gamma Value for Remote Scans].
2 Select the desired gamma value ([Gamma 1.0], [Gamma 1.4], [Gamma
1.8], or [Gamma 2.2]) ➞ press [OK].
The selected mode is set.
Returning the Common Settings to Their Defaults
You can restore all of the Common Settings to their defaults (initial settings).
NOTE
If you set Language Switch to 'On', and then return the Common Settings to their default settings,
Language Switch is turned 'Off', but the language shown on the touch panel display remains
unchanged. (See "Changing the Language Shown on the Touch Panel Display," on p. 4-47.)
1 Press ➞ [Common Settings] ➞ [Initialize Common Settings].
2 Press [Yes].
To cancel initializing the Common Settings, press [No].
The message <Initialized.> appears for approximately two seconds on the touch panel display.
The Common Settings are returned to their defaults.