User`s guide

Specifying Common Settings
4-39
4
Customizing Settings
NOTE
• To enter values in inches, press [Inch]. You must first specify to set Inch Entry in Common
Settings (from the Additional Functions screen) to 'On'. (See "Auto Paper Selection/Auto Drawer
Switching," on p. 4-23.)
• For instructions on entering values in inches, see "Values in Inches," on p. 2-32.
• If you make a mistake when entering values, press [C] on the touch panel display ➞ enter the
correct values.
• To select a paper size stored in a size key ( [S1] to [S5] ), you need to store the irregular paper
size in the key beforehand. For instructions on storing irregular paper sizes, see "Irregular Paper
Size Settings for the Stack Bypass," on p. 4-41.
❑ Press [Next].
● If you want to select an envelope size:
❑ Press [Envelope].
❑ Select the envelope type ➞ press [OK].
The display returns to the paper size selection screen.
IMPORTANT
If the envelope type is not selected correctly, a paper jam will occur.
❑ Press [OK] ➞ proceed to step 5.