User`s guide

Specifying Common Settings

4-27

Customizing Settings

Select the desired paper type loaded in the paper source ➞ press [OK].

Make sure that the registered paper type setting is the same paper type that is loaded in the

paper source.

If you selected the optional Paper Deck-P1 as the paper source in step 2, [Transparency] is not

displayed on the Register Paper Type screen.

The selected mode is set.

IMPORTANT

•

When printing on special types of paper, such as heavy paper or transparencies, be sure to

correctly set the paper type, especially if you are using heavy paper. If the type of paper is not set

correctly, it could adversely affect the quality of the image. Moreover, the fixing unit may become

dirty, or the paper could jam, and a service repair may be needed.

•

If you select [Transparency] as the paper type loaded in the paper source but load plain paper

instead, a paper jam may occur. Make sure to load transparencies into the paper source.

NOTE

•

For more information on paper types, see "Available Paper Stock," on p. 2-64.

•

The registered paper type information is displayed through the use of icons on the paper

selection screen, as shown below.