User`s guide

Finisher-N1/Saddle Finisher-N2

3-18

Optional Equipment

IMPORTANT

•

The following types of paper are output to the centre output tray of the main unit and not to the output

tray of the finisher: 320 mm x 450 mm paper, envelopes, tracing paper, transparencies, labels, tab

paper, and Japanese paper.

•

Finishing modes cannot be set if you are using 305 mm x 457 mm paper.

NOTE

If the Collate or Group mode is set, the output trays move downward as each set of prints are output.

Once an output tray has reached its stacking limit, subsequent prints are automatically delivered to the

next available tray. If all of the available trays have reached their stacking limits, printing stops

temporarily. Remove all output paper from the trays. The trays move upward, and printing resumes.

■ Collate Mode

The prints are automatically collated into sets arranged in page order. The collated print sets can be

shifted by pressing [Offset].

■ Group Mode

All prints of the same original page are grouped together. The grouped print sets can be shifted by

pressing [Offset].

■ Offset Mode

The print output is shifted alternately to the front and back of the tray, in a vertical (portrait) orientation, or

a horizontal (landscape) orientation depending on the orientation of your originals.

NOTE

If you press [Offset] when either the Collate or Group mode is set, each set of prints is shifted about 30

mm before it is delivered to the output tray.