User`s guide

Finisher-N1/Saddle Finisher-N2
3-17
3
Optional Equipment
a Top Cover
Open this cover to remove jammed paper. (See
"Finisher-N1/Saddle Finisher-N2 (Optional)," on p. 8-49.)
b Release Button
Press to move the finisher away from the main unit.
c Upper Front Cover
Open this cover to replace the staple cartridge in the
stapler unit, or to clear a staple jam. (See "Replacing the
Staple Cartridge in the Stapler Unit," on p. 7-20, and
"Finisher-N1/Saddle Finisher-N2 (Optional)," on p. 8-60.)
d Lower Front Cover (Saddle Finisher-N2 Only)
Open this cover to replace the staple cartridge in the saddle
stitcher unit, or clear a staple or paper jam in the saddle
stitcher unit. (See "Replacing the Staple Cartridge in the
Stapler Unit," on p. 7-20, "Saddle Stitcher Unit (Optional),"
on p. 8-53, and "Saddle Stitcher Unit (Optional)," on p.
8-64.)
e Booklet Tray (Saddle Finisher-N2 Only)
Prints that are saddle stitched are output to this tray.
f Booklet Tray Guide (Saddle Finisher-N2 Only)
Set this guide to match the size of the output paper. (See
"Finishing Modes," on p. 3-17.)
g Output Tray B
Prints are output to this tray. You can set the Tray
Designation mode to designate this tray for outputting prints
when using certain functions. (See "Output Tray
Designation," on p. 4-30.)
h Output Tray A
Prints are output to this tray. You can set the Tray
Designation mode to designate this tray for outputting prints
when using certain functions. (See "Output Tray
Designation," on p. 4-30.)
Finishing Modes
The Finisher-N1 and Saddle Finisher-N2 are equipped with the following finishing modes.
CAUTION
• Do not place anything other than output paper on the trays of the finisher, as doing so may
damage the trays.
• Do not place anything under the trays of the finisher, as doing so may damage the trays.