User`s guide

Finisher-M1
3-15
3
Optional Equipment
IMPORTANT
• If the Staple mode is set, the output tray moves downward as the stack of paper that is output increases
in quantity and thickness. Once the output tray has reached its stacking limit, or after 30 sets of prints
have been output, printing and stapling stop temporarily. Remove all of the stapled prints from the
output tray, and printing and stapling resume.
• Only the following paper sizes can be stapled: A3, A4, or A4R.
• You cannot staple envelopes, glossy paper, transparencies, tracing paper, labels, tab paper, or
Japanese paper.
NOTE
• The maximum number of sheets, including cover sheets, that can be stapled together is as following:
-A4, A4R:
30 sheets (64 to 80 g/m
2
)
20 sheets (81 to 105 g/m
2
)
5 sheets (106 to 253 g/m
2
)
-A3:
15 sheets (64 to 80 g/m
2
)
10 sheets (81 to 105 g/m
2
)
5 sheets (106 to 253 g/m
2
)
• If the machine stops while stapling and the message <Load staples.> appears, almost all of the staples
have been used, and the staple cartridge must be replaced. To proceed, replace the staple cartridge.
(See "Replacing the Staple Cartridge," on p. 7-15.)