Service manual

B. Interface Controller PCB
1) Remove the 3 screws
➀ Screws
Figure 3-7-2
2) Remove the 3 screws and pull the inter-
face controller unit to place it down.
➀ Screws
➁ Interface controller unit
Figure 3-7-3
3) Disconnect the 2 connectors and
remove the interface controller unit.
➀ Connectors
➁ Interface controller unit
➂ Interface controller PCB
Figure 3-7-4
4) Remove the 4 screws and then the
interface controller PCB.
<< Note for reassembly >>
Make sure to install each of the two con-
nectors in the right positions when
installing the interface controller unit.
CHAPTER 3
3 - 20
➀
➁
➂
➀
➁
➀