Service manual

D. Transfer Charging Roller
1) Open the cartridge cover unit.
2) Holding the 2 claws on the left side of
the bushing, lift the transfer charging
roller, and then slide it to the left to
remove.
➀ Bushing
➁ Transfer charging roller
Figure 3-4-7
Note: Hold the shaft of the transfer
charging roller. Do not hold the
sponge area.
E. Pressure Roller
1) Performing the drive unit removal pro-
cedures on page 3-6, remove the drive
unit.
2) Performing the fixing unit removal pro-
cedures on page 3-8, remove the fixing
film unit.
3) Remove the 2 screws and then the fix-
ing entrance guide.
4) Remove the holder.
➀ Screws
➁ Fixing entrance guide
➂ Holder
Figure 3-4-8
CHAPTER 3
3 - 13
➁
➂
➀
➀
➁