Service manual

III. MAIN UNITS
A. Laser/Scanner Unit
1) Remove the external covers.
2) Disconnect the connector, and then
remove the cable from the cable guide.
3) Remove the 2 screws, then the display
unit.
➀ Connector ➁ Cable guides
➂ Cable ➃ Screws
➄ Display unit
Figure 3-3-1
4) Remove the 2 screws, then the right
and left covers.
➀ Screws ➁ Covers
Figure 3-3-2
5) Remove the 2 screws and 2 claws, then
the duct.
➀ Screws ➁ Claws
➂ Duct
Figure 3-3-3
6) Remove the sponge.
➀ Sponge
Figure 3-3-4
<< Note for reassembly >>
Make sure to confirm the sponge attached,
when installing the duct.
CHAPTER 3
3 - 5
➀
➂
➀
➄
➁
➃
➁
➀
➁
➂
➀