Fax Machine Users Guide
Table Of Contents
- Using this guide
- Important safety instructions
- For your safety (Australia only)
- Caution (New Zealand only)
- SETTING UP
- PREPARING TO USE YOUR FAX
- Main components of your fax
- Fax controls - the operation panel
- Guidelines for entering numbers, letters, and symbols
- Setting the TEL LINE TYPE
- Dialing through a switchboard (PBX)
- Registering sender information
- Registering one-touch speed dialing numbers and names
- Registering coded speed dialing numbers and names
- Registering UCanTalk voice tags
- DOCUMENTS AND PAPER
- MAKING COPIES
- SENDING DOCUMENTS
- RECEIVING DOCUMENTS
- USING TAM MODE (FAX-B840 only)
- SETTINGS AND ACTIVITY REPORTS
- SOLUTIONS TO COMMON PROBLEMS
- Specifications
- Index
5-5
SENDING DOCUMENTS
5
Canceling sending
Automatic dialing
Sending a document using one-touch speed
dialing or coded speed dialing numbers_______
To use this feature you must first register numbers for one-touch speed dialing (see pp. 2-12, 2-
13) or coded speed dialing (see p. 2-14).
1
Press [Stop].
1
Load the document face up into the document tray.
See Loading documents, p. 3-2.
You can set the scanning resolution and the contrast (see p. 5-1).
2
Press the one-touch speed dialing button under which the number you wish to fax is
registered.
-or-
Press [Coded Dial/Directory] and enter the appropriate two-digit coded speed dialing
code.
The registered name and number appear.
If you make a mistake, press [Stop]. Then press the correct one-touch speed dialing button or press
[Coded Dial/Directory] and re-enter the code.
3
Press [Start/Copy].
The fax begins sending.
• When you cancel sending, you may need to press and hold [Start/Copy] for a few seconds,
then the fax will feed out the document.
• You can set whether or not the fax prints an ERROR TX REPORT (see p. 8-3).
905 795 xxxx
1 49 39 xx xx