Specifications

Scanning Film
15
English
Scanning Film
The following steps explain how to scan the film with ArcSoft PhotoStudio.
1 Press the power switch on the scanner’s left side to set it to the ( I ) position.
2 Start ArcSoft PhotoStudio.
Refer to step 2 on page 7.
3 Start ScanGear CS.
Refer to step 4 on page 8.
4 Select the [Select Source].
You can select from the following options for films.
Negative Film (Color) / Positive Film (Color)
5 Click [Preview].
ScanGear CS will display the preview image(s).
6 Place a check mark beside the number(s) of the
frame(s) to be scanned.
By default, a check mark appears beside the first frame only.
You can scan multiple frames in one step if you place a check
mark beside the number of each frame you wish to include.
7 Select the [Destination].
You can select [Print (300 dpi)] or [Image display (150 dpi)].
When [Print (300 dpi)] is selected, the output resolution is set
to 300 dpi. When [Image display (150 dpi)] is selected, it is set
to 150 dpi.
[Print (300 dpi)] is selected in this example.