Specifications

Scanning Film

English

2 Insert the film into the Film Guide.

35mm Film Strip

c Open the film holder on the film guide, place the film face down and close the film holder.

d Align the Film Guide’s tab with the FILM symbol on the document glass of the scanner.

35mm Slides

c Align the Film Guide’s tab with the FILM symbol on the document glass of the scanner.

d Place a slide or slides face down (correctly viewed from

below) in the Film Guide as shown in the diagram to the

right.

• Hold the film by the edges with your fingertips to avoid getting fingerprints or dirt

on the film surface.

• Use a blower brush to remove any dust from the film, document glass or light source

unit.

• Do not block the calibration slot on the Film Guide when you are scanning film.

Colors will not be scanned correctly if the calibration slot is obstructed.

• Place a black piece of paper over any gap to shield the light if you are inserting a film

strip with 5 or fewer frames, or if the edge of a scanned image appears whitened.

• Ensure that there is no gap between the edge of the film and the film guide on the

side near the calibration shot.

Calibration Slot

Film Holder